Can you use a metal lathe for wood? - cue lathe for sale
My brother gave me the taco bueno .... 9 mm conical, I am sure that today I am a new 12 mm and is like playing with a tree trunk to another signal, not even I could see the ball much in relation to others, I think, in the upper half of the signal the school and with the metal lathe with the sailing school at 9 mm, 7 mm, it is possible to do?
Thank you very much appreciated
Cue Lathe For Sale Can You Use A Metal Lathe For Wood?
Tuesday, February 23, 2010
|
Subscribe to:
Post Comments (Atom)
1 comment:
Riley
while I'm no expert on the bike, I have a fair share of work on this issue. Could probably use the wheel without any problems in the forest, it would be difficult to find the absolute center at both ends, then apply evenly. What I mean is that most of the wood is essentially the central point, then small adjustments in the process of recording. In the case of a conical heel, you can not find the absolute center, and in the process of switching to a balanced turn, does not have sufficient stock at the end (in particular), the conical point. We talked again, and is centered within 2 mm. If you are not lucky, but I was a little Leary.
I thought of her own signal, but higher values, of course. In any case, good luck - I hope, "is" good for you.
Post a Comment